Close

Search:

Type: Posts; User: Terry@BMS

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    35
    Views
    1,029

    https://www.youtube.com/watch?v=Bry0rdUo3RY

    https://www.youtube.com/watch?v=Bry0rdUo3RY
  2. Replies
    35
    Views
    1,029

    Thanks! Hurry up and pass me so I can set the bar...

    Thanks! Hurry up and pass me so I can set the bar higher. ;)
  3. Replies
    35
    Views
    1,029

    I tried a "hard" launch with lots of brake boost...

    I tried a "hard" launch with lots of brake boost and no cap in 2nd and it blew the tires off. Since I figured the day was likely to get rained out I didn't bother bringing my drag tires. Plus I know...
  4. Replies
    35
    Views
    1,029

    I may have the slips in the car still, I'll have...

    I may have the slips in the car still, I'll have to check. 2.3-2.4 range though. Running down 150whp for the 1/3rd of the run isn't going to help your traps much. So it's to be expected. Not to be...
  5. Replies
    35
    Views
    1,029

    I think the slow 2nd gear launch was hurting the...

    I think the slow 2nd gear launch was hurting the trap a bit. On runs where I left even softer traps were down a bit. I'll go back and up the trap record soon. I think the previous N54 record was...
  6. Replies
    35
    Views
    1,029

    A couple others at 135mph. Nothing very exciting....

    A couple others at 135mph. Nothing very exciting. The track seemed a bit slower today too FWIW. Weather was cold but lower pressure and wet air.
  7. Replies
    35
    Views
    1,029

    Trans held up just fine. Although 26psi is only...

    Trans held up just fine. Although 26psi is only ~630whp.
  8. Replies
    35
    Views
    1,029

    Hey guys, Added a log to the first post!

    Hey guys,

    Added a log to the first post!
  9. Replies
    35
    Views
    1,029

    New n54 trap record

    I was able to attend a track day at Famoso raceway today. The scheduled start time was 9am but that got pushed back due to a rain delay. It was around noon before we got to do any runs.

    I decided...
  10. Replies
    5
    Views
    136

    Also have an in dash boost gauge & LED HALO...

    Also have an in dash boost gauge & LED HALO options included now. :)
  11. I think Jake mentioned it was a $30k sort of a...

    I think Jake mentioned it was a $30k sort of a tuning solution for their custom race car.
  12. The gearing is probably helping spool a bit. Both...

    The gearing is probably helping spool a bit. Both logs are from the motiv kit. See my fftec threads for logs on that kit.
  13. Gracias.

    Gracias.
  14. I know it's always difficult to get an apples to...

    I know it's always difficult to get an apples to apples type comparison. But at the end of the day boost is boost. If it's making the boost and IATs are not going crazy it's going to make similar...
  15. That's as high as it will rev on an auto. I don't...

    That's as high as it will rev on an auto. I don't connect boost reference on the dynojet, as I'm working from JB4 logs when tuning.
  16. No, it's another series of tables that should...

    No, it's another series of tables that should allow flash boost targets to be raised up to 20psi across the board.

    i8a0s has a higher ceiling for some reason so normally isn't as much of an issue...
  17. Guys, I almost forgot to post my same day...

    Guys, I almost forgot to post my same day baseline! This is off the WG spring @ ~9psi. lol.

    http://www.bimmerboost.com/images/imported/2015/02/attachmentphpattachmentid27840stc1d14243-1.jpg
  18. You can use the free software or Cobb. For single...

    You can use the free software or Cobb. For single turbo automatics in ije0s, I prefer the Cobb environment, because I can push torque higher with it than I can with the free software due to its race...
  19. Mostly was adjusting the AIC fuel controller as...

    Mostly was adjusting the AIC fuel controller as it's been rescaled now with the new 5v input. Other than that a little duty cycle tuning on the JB4 and that was it. But Jake sent over some tuning...
  20. Idle tables would be nice. :)

    Idle tables would be nice. :)
  21. MOTIV 750 Dyno Testing

    Hey guys,

    Was able to finally get our 135i up on the dyno today for a little tuning with the new MOTIV kit. Overall, the kit is pretty impressive. Build quality is top notch and everything...
  22. Replies
    13
    Views
    328

    Mainly for visual differentiation. And, we have...

    Mainly for visual differentiation. And, we have 1000 of those old smaller enclosures in stock, so this is a good way to slowly get rid of them. ;)
  23. Replies
    192
    Views
    3,846

    Hopefully you guys are able to make quick...

    Hopefully you guys are able to make quick process! Unfortunately I don't have the time right now to help test it out. Knee deep in too many other projects. Sorry. :(
  24. Replies
    5
    Views
    136

    Another addition we're testing... Active Sound...

    Another addition we're testing... Active Sound Mute!


    https://www.youtube.com/watch?v=z1SSos2phWU
  25. Replies
    455
    Views
    11,543

    Two new disks and a pressure plate.

    Two new disks and a pressure plate.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4